Cannot open "Configure" on Client 4.8.8

4 posts / 0 new
Last post
eraymond
Cannot open "Configure" on Client 4.8.8

Just updated to the latest client 4.8.8, rebooted, and installed driver (it did not install during the reboot as I assumed when prompted). This in on OSX 10.14.6.

When I click configure on the hub properties screen, nothing happens.

The virtual here usb works fine though! The server is on 4.0.0.

Michael
.

What are you running the server on?

eraymond
Raspberry Pi 3+ ... which has

Raspberry Pi 3+ ... which has always worked with prior clients.

FYI, the version number is what's reported by the client. Would be easier if the binary/distribution files had a version number in their name or readme.

Michael
.

1. I assume you are using CloudHub for the Pi3b NOT the Pi3B+, virtualhere cloudhub is not supported on the pi3b+ and never has been
2. If you are using a pi3b , then there should be a Configure button in Hub Properties, and when you press that it will ask for a password
3. If you are using any other image of virtualhere then it shouldnt show the configure button
4. I installed an image of the cloudhub firmware for my Pi3B and it shows correctly in osx 10.14.6 and the configure buttons works and asks for a password.

Log in or register to post comments