Page not found

About searching
  1. Client Stopped Connecting To Servers

    Client Stopped Connecting To Servers I'm running the virtualhere …

    shalamigri - 2019/01/15 - 09:41 - 2 comments

  2. VirtualHere USB Client Changes (3.4.8 onwards)

    VirtualHere USB Client Changes (3.4.8 onwards) If you … ----------------------------- * Improved - when client is connecting to a hub, these are listed at the bottom to avoid … terminated" message that is displayed when the service is stopped via the net stop command 4.2.9 (1st Oct 2017) …

    Michael - 2024/03/28 - 08:10

  3. VirtualHere USB Server Changes (2.7.5 onwards)

    … the USB Hub structure when combined with VirtualHere Client 5.5.8 or later. Fixed set nickname in GL-AR300M16 … fixed potential crash that occured when a device was stopped being used * Added - if the VirtualHere OSX server … Raspberry Pi0W/Pi3+/Pi3B+ the firmware can also be reset by connecting pin 1 to pin40 for 2 seconds * All CloudHub …

    Michael - 2024/03/15 - 19:23

  4. Problems with Synology and hubs. What is the best setup for VH?

    … started to use them and after several hours all the keys stopped working. Let me explain. The keys were visible in … 16 and the pi for 10 devices , since that is stable. The client can connect to multiple servers at once so end users … 1x RPi3) with the latest CloudHub 4.1.1. After booting and connecting various amounts of hubs and usb keys, I have some …

    Kokos - 2019/10/14 - 08:01 - 20 comments

  5. OpenTPCast rumble only on one controller

    … . In the virtualhere client, right click on the TPCast Hub and select Properties … to a usb 3.1 (or 3.2) port on their mother board and connecting it via a 3.0 or 2.0 solved their issue. I … errors, but also not audio device was showing up. I then stopped the virtual here service on the tpcast before …

    rdpeake - 2019/02/09 - 01:54 - 73 comments

  6. PS4 controller cannot reconnect on bluetooth

    … I have also tried to use client as a service, and to start with admin rights, it did … and it stays active in the software even before connecting my DS4. Once I paired a controller to it and it … before connecting, but It also happens when I leave It stopped when connecting and start It after joysticks are …

    famus484 - 2021/07/30 - 10:16 - 33 comments

  7. "Device cannot be shared" requiring reboot?

    … #20 From the client can you send From … Disk Manager... Dec 5 07:14:51 SVR-USB systemd[1]: Stopped target Graphical Interface. Dec 4 07:35:02 … [1480886132.5648] manager: NetworkManager state is now CONNECTING Dec 5 07:15:32 SVR-USB whoopsie[777]: …

    sluthy - 2016/12/05 - 07:41 - 3 comments