Support

I've installed VirtualHere as a service without Bonjour using -b and am able to run vhui64.exe -t help just fine, and -t list gives me the current status, but I cannot connect to the same hub that I was using prior to installing as a service by running:
vhui64.exe -t use,192.168.1.169
I simply get ERROR: Invalid Address

The Windows firewall is off for troubleshooting, and I can ping and ssh to the hub just fine.

What am I doing wrong?

Please show the Serial Number in the VH Client, so that multiple devices of the same type can be distinguished.

I have a number of development boards that have on-board SEGGER J-Link debug chips. They all show up as J-Link in the Client so it's not easy to tell which one I need to use.

I notice there is a property option (right-click drop-down) and it shows all the details.

Hello,
while using Razer Naga without Virtual Here I have 0% frame loss and lags, but I can't use 12 button thumb grid. When I enable Virtual Here all buttons work but I get up to 40% frame loss (unplayable) when I move the mouse.

I assure you that network isn't the problem. I tried both wired and wireless with same results. Only time I get frame loss is when using Razer Naga over Virtual Here. Tested on Borderlands 2 @ 30 FPS and @ 60 FPS, no difference.

Can you assist me with this issue?

Hello!

I need some way to determine from which IP addresses OS USB devices (from the lsusb output) came from. I was trying to implement this using device serial numbers, but for some strange reason DEVICE INFO command just stopped working and now prints an empty line. usbip -p command prints 'unknown host' for all connected devices. Is there any other ways to make a list mapping lsusb output to servers' ip addresses?

Hi Michael,

For my first use, I would like to use an Extigy Sound Blaster card connected to my NAS Synology DS215j (DSM6) from my Windows 7 machine.

Situation:
- Server : VirtualHere Server 3.1.9 for NAS DS215j DSM6.
- Client : Windows 7.
- Device : sound card Extigy Sound Blaster

- VirtualHere Client GUI show the hub and the attached devices , ie Sound Blaster and the UPS.
- VirtualHere USB Root Hub and VirtualHere USB HostController drivers are presents.

Hi,

I'm getting following error for an ANT+ usb dongle I'd like to share in my network.

My setup is as follows:
- Raspberry PI B+ powered with 5V 3A
- USB Hub powered with 5V 2.1A
- TP Link TL-WN722N 150Mbps USB Adaptor (connected to the USB Hub)

Wifi is working as expected and everything is ok (using e.g. SSH to install VirtualHere Server) until I connect with a VirtualHere client (Windows in this case) to the Server.
As soon as I do that the Wifi Dongle shuts down and does not work anymore. IgnoredDevices is empty in the config.ini file on the server.

Hi

I've recently installed VirtualHere and it is working ok for most of my devices with the exception on a SBIG camera.

The device is shown ok in the client as "USBI-CAM Engine", when I select use this device I get an error "There was a error using this device".

Hi there!

On what Android systems does this app work?
PlayStore says my Samsung Tab E is not compatible with it so I tried to install manually by downloading the apk. But that also does not work... :-/

Greetings

Hi,

I'm running client in administrative mode to be able to disconnect other users. I find it only possible via GUI. Is there any option to disconnect other users via IPC command? The best would be to have an option which performs like that: check if other users are using device, if so - disconnect them and start using a device.

Best regards,

MM