Support

Hi
I´m trying to get Virtualhere to run on Boot at my RaspberryPi Zero

I´m installing using the scrip at https://github.com/virtualhere/script
An as far I can understand from the FAQ Virtualhere should run at boot if it was installed by the script but it dosen´t.
I´m running a Pi Zero with Zero4U usb HAT. Connection is a 4G LTE USB modem and it works fine to ssh into the machine but when i do ps -A there is no vhusbdarmpi there.
Any sugestions?

As the title states, I just recently purchased VirtualHere through Steam, for use with my Steam Link. However, I cannot get any devices to connect to my PC. I'm trying to use my Logitech Extreme 3D flight stick with Elite Dangerous specifically, but I have a G29 wheel and other devices as well that I will be using. The flight stick works as expected when plugged into my PC directly.

Hello good day. I am trying to get cloudhub up and running with a Raspberry 3B to manage a genset controller. The direct USB cable controller emulates a COM port which the software uses to connect. When trying to use it through cloudhub, it is detected, but it constantly gives me CRC errors in communication. Are there possibilities to correct this behavior? Thank you

Hello,

Hi, I'm trying to use my X52 Pro HOTAS on my Shadow PC using VirtualHere. Getting bind errors, server log says it is in use, but I have no clue what could be using the device. Here's the offending log entries.

2021-04-19 20:53:43 INFO :Connection 1 successfully removed (reason:server shutdown)
2021-04-19 20:53:43 INFO :Connection 2 successfully removed (reason:server shutdown)
2021-04-19 20:53:43 INFO :Connection 2 successfully removed (reason:timeout)
2021-04-19 20:53:44 INFO :Connection 3 successfully removed (reason:server shutdown)
2021-04-19 20:53:44 INFO :Connection 3 successfully removed (reason:timeout)
2021-04-19 20:53:45 INFO :Unmanaging device 4 [058f:9540]
2021-04-19 20:53:45 INFO :Unmanaging device 5 [058f:9540]

I bought yesterday a server license for my Raspberry pi 4 Model B and I was able to succesfully use a Canon LiDE 200 scanner under Windows 10 Pro.

However I cannot say the same for my Canon PIXMA iP4300 (https://www.canon.com.au/printers/pixma-ip4300/support).

If I try to autoenable (or manual enable) it in your Windows client I keep hearing the system connect / disconnect sound going on all the time until I stop it.

Working with the Demo to see if it meets our needs, and I am encouraged out of the gate! One thing I am hearing some artifact sounds that don't exist with the physical connection. The best way to describe them is like a scratch on a record or a dirty needle on the record player (yep that old). The sound can be perfect for 20 - 30 sec then the artifact takes place. Sometimes there is a noticeable 'interference sound like AM radio or a stumble (lost packets ?)

So wanted to try out a wireless face tracker setup using the new HTC Facial Tracker but I have been unsuccessful so far. My Windows desktop sees the Android Hub no problem but it doesn't ever see the HTC Camera which is currently directly attached to my phone via USB-C.

Any thoughts on troubleshooting steps?

Hello,
unfortunately I noticed that the confirmation dialog before kicking a user off a device (introduced in 5.0.6) was removed in version 5.1.5.

For us this was a great improvement, because often an user accidentally kicks another user by double klick (sometimes they slip or dont see that the device is in use).
I hope you can reintroduce this behavior.
Maybe it is possible to add an 'diconnect from user'-function with confirmation in non-admin mode or to disable/enable confirmation in the settings.

thanks in advance