Support

Dear,

I'm trying to connect several devices to my client (yes, I do have license for the server)
I am also using the server: https://www.virtualhere.com/sites/default/files/usbserver/vhusbdwindk64…
(the vhusbdwin64.exe always fails)

The server is Windows 10 x64 computer and the client is a Windows 10 x64

Some devices is OK.

I tried to share a common DataTraveler 2.0 USB memory from VirtualHare Linux server has virtualhare Windows 10 client and everything works.
On the contrary, using OSX server and Windows clinet the same USB memory does not work
Is there a solution to make it work also from OSX servers?

Using Oculus Quest 2 with a Vive facial tracker.
Both on my phone and Quest, VirtualHere seems to be skipping frames (the facial tracker is essentially a camera), the tracker when normally plugged in using usb shows very tiny movements, but using VirtualHere it seems to be skipping all small changes. There is also around 1 second of latency which isn't there when using USB.

Has VirtualHere recently updated their camera compression to remove these smaller changes or is there something wrong with my setup?

Hi,

Suppose i have to raspberry pi's on different location's (one in the garden and one in the cellar) but in the same network. Can ik connect to both pi's at the same time from one client (W10-x64)?
Is it correct that the license is bound to the client? So this config would count for one (1) license?

Regards,
Edwin

Hi,

Took a raspberry pi 3B (not the +) and burned img on to it an got it running (trial version) directly connected via ethernet cable. Fixed IP from router.
From a w10x64 box i used the client and are able to see and use a USB flash disk.

Hi,

I'm new to linux and I want to install virtualhere client on Ubuntu. The server is on steam link.
I downloaded the vhuit32 file but I dont know what to do with it. I made it executable but that didnt work.
Can someone please help?

Hi
I´m trying to get Virtualhere to run on Boot at my RaspberryPi Zero

I´m installing using the scrip at https://github.com/virtualhere/script
An as far I can understand from the FAQ Virtualhere should run at boot if it was installed by the script but it dosen´t.
I´m running a Pi Zero with Zero4U usb HAT. Connection is a 4G LTE USB modem and it works fine to ssh into the machine but when i do ps -A there is no vhusbdarmpi there.
Any sugestions?

As the title states, I just recently purchased VirtualHere through Steam, for use with my Steam Link. However, I cannot get any devices to connect to my PC. I'm trying to use my Logitech Extreme 3D flight stick with Elite Dangerous specifically, but I have a G29 wheel and other devices as well that I will be using. The flight stick works as expected when plugged into my PC directly.

Hello good day. I am trying to get cloudhub up and running with a Raspberry 3B to manage a genset controller. The direct USB cable controller emulates a COM port which the software uses to connect. When trying to use it through cloudhub, it is detected, but it constantly gives me CRC errors in communication. Are there possibilities to correct this behavior? Thank you

Hello,