Support

Hi!

Would it be possible to add a monitoring/sniffing interface to either the client or the server so that one can capture the complete traffic
between the host and the device?
(Control-, Bulk-, Interrupt-, Iso-transfers for all endpoints)
Could be helpful for embedded firmware development on small microcontrollers.
Eg.: http://www.fourwalledcubicle.com/LUFA.php (USB host and USB device support for Atmel AVR µCs)

Cheers,
Nano

hello
I can not get to a Raspberry with virtualhere, I get this in the log:

23:21:20 INFO :VirtualHere 1.9.2 starting (Compiled: Dec 6 2013 23:21:43)
23:21:20 INFO :Using config at C:\Documents and Settings\Administrateur\Application Data\vhui.ini
23:21:20 INFO :Starting Bonjour...
23:21:20 INFO :Bonjour started
23:21:20 INFO :Starting Manual Lookup...
23:21:20 INFO :Manual Lookup started
23:47:21 INFO :handleConnect error Aucune connexion n'a pu être établie car l'ordinateur cible l'a expressément refusée (192.168.1.12:7575)

Hi,

I recently installed VH on my RPi and on my Pc. It works fine, i find my RPi in the list and i can see which devices are connected.
I tried to connect a normal mouse to test it. But i cannot use the device. I always get the following error (even if i change the device):

Error:

The VirtualHere Drivers could not be loaded.
Please reboot your machine and run VirtualHere again to install/upgrade the drivers.


Hello Michael,

do you have any plans for a Linux client as well?

Thanks,
Christian

I installed VH on a Raspberry PI last week to share data from a weather station. Everything was rock solid for about five days, but recently the client has started dropping the connection several times an hour. I've attached the log messages from the latest crash below. The cycle of messages is repetitive, with the same series of six lines over and over.

Hi,
using QPKG Center, the installation don't create folder under ../.qpkg/ with all files.
In web UI i see "installation complete" but missing all files!
Why?

Thanks,
Franco

Hi,

i have a mid 2011 macbook air running maverick that is not able to run your client. all it does is show a loading beach ball after it announces that virtual here drivers will be updated upon running of the client.

pls assist.

PS: my other mac mini running maverick is able to work.

tks.

Hi there,
first of all: A great piece of Software!

I have the VH client running on my mini homeserver to extend a vcp USB Device of a raspberry pi.
But I had to notice that my server (that is optimized for 24/7 usage) is getting slower and slower - until after arround 2 days I have to hardreset it because it has gotten so slow that it wouldn't even restart while producing a lot of critical application errors.
The processor usage is at 1% - but the memory has run out.

I get an error message when I try to connect to a raspberry pi from one of my machines:

17:25:23 INFO :Drivers are up-to-date
17:25:23 ERROR :Hub failed to open error, access is denied. (0x00000005)

Raspberry is working fine if I use another machine and connect to it

The machine that's not working is a W7 x64

Client 1.8.0
Server 1.6.4