Support

I'm using the Mac OS Server and Windows 10 client. Every few minutes the device I'm using will disconnect and 1-30 seconds later reconnect to eventually start the cycle over. I'm using a wired connection on both platforms, both exceeding 200Mbps up/down at any given time.

<p>I'm considering purchasing Raspberry Pi 3B for CloudHub because of its four USB ports. But other products listed in the "Hardware" page seem to implement only one USB port. I'm worried if the CloudHub server software supports only one USB device per server.
</p>
<p>All ports on Raspberry Pi 3, or some other product with a USB hub, are simultaneously available to CloudHub? I'm sure there must be enough power supply so that connected devices work properly.
</p>
<p>Thanks</p>

Trying to setup authorization from a Windows 7 client to a Windows Server USB Server. Both installed as services. Followed the instructions listed here https://virtualhere.com/authorization but no luck. The connection goes through without any authorization at all.

Please help.

I BUY a 20-port usb hub, and a raspberry zero w;i Write the firmware on the raspberry.when i plug 20 usbs into hub.
i only see 8 device on the virtual here client list.
i have a window7 pc.i plug this hub into pc.i can see 20 device on the virtual here client list.

I just installed the VirtualHere server (version 3.2.9) on our Synology DiskStation yesterday. I have installed the VirtualHere Client (version 4.5.7) on our Mac Server OSX 10.8.5. The client is able to connect to our Synology Hub and lists the available USB devices. Whenever I right click on the USB device with ´Use this device`, the client indicates that the `drivers will to be updated`. I run through the update installation only to receive the following message at the end:

Hi, i use synology DS710+ (licensed) two usb keys work, but when connecting the third key there are errors:

I have a server in reverse mode and a client in listen mode.

All run from the CLI.

How do I generate the text needed to purchase a license?

Thanks again!

I think I have an issue with my Android VH Server. I had been using the easy connect feature previously without issue. My SysLog ends with :

"PropClient failed to load"

Thanks

Hello,

So I have my Raspberry Pi as the server and running the client on my MacBook. Everything works fantastic with the software however when my Mac is put to sleep it ejects the disk. I have tried my hand at Google-fu (which is how I came across this forum) and I've looked at the config.ini file but I wasn't clear on if there was a certain value I could add server-side that would force the disk to remain connected.

Any assisted would be appreciated.

Thank you.

I want the VH server to start automatically after boot on Odroid running Ubuntu.
I followed the Linux OEM_FAQ https://www.virtualhere.com/oem_faq "How to i start VirtualHere when my device boots?", For init.d based systems (Raspberry pi, Ubuntu...)
except that I use the optimized server version vhusbdarm64a53 which runs on Odroid. In the file vhusbdpin I have edited the NAME to match the server's filename.
It worked when I started the server manually but not after the above changes - client finds no server.
License is ok.