Support

Hi all (From: Pi noob)

What I'm trying to achieve is to have my Xbox 360 wireless controller connect to a wireless dongle that is attached to a USB port on the Pi.
Then to use the LAN cable connected to the Pi to send the signal to my Windows 8 x64 PC.

I am able to get the Pi + Wireless dongle + Controller talking with the following commands:
sudo dmesg | grep Xbox
sudo xboxdrv -w 0 --controller-slot 0
sudo rmmod xpad
sudo xboxdrv -w 0 --controller-slot 0

Hi,
after starting VirtualHere and trying to connect to a Samsung SCX-5x12 device I go an error:
"The VirtualHere Drivers could not be loaded. Try rebooting..."
The log says:
17:45:44 INFO :Drivers are up-to-date
17:45:44 INFO :CreateFile failed
17:45:44 ERROR :Hub failed to open error, zugriff verweigert (0x00000005)

The host is a QNAP TS-870 pro,
VirtualHere 1.8.1, unlimited devices.

Going into Details: the device is recognized correctly.

Trying to start debug mode: same error occured

I'm attaching a MCE infrared transceiver to my raspberry and from the client software it shows up and I can click to use it. But in Windows device manager the device gets a yellow exclamation mark (device cannot start). If I plug it in to the PC directly it works fine. Is there something that needs to be done in the raspberry to get it working? any drivers that needs to be installed?

Hello,

I just try VirtualHere on my Qnap TS-419P (QTS 4.1 RC3).
When I plug an USB key or printer device on the Qnap, I get an alert : [virtualhere] Failed to read '/sys/devices/virtual/bdi/0:15/uevent', Resource temporarily unavailable

Any idea ?

Thank you.

Hi,

i'm trying to use VirtualHere to share audio from a kinect which i have connected to a raspberry, i have understood that i could not share the webcam part using the raspberry but i only need audio for now.

I have installed the server on the raspberry and run it without too much problem, i have installed the client on a windows computer, i can see the server and use the "Kinect USB Audio" remote device.

I'm having problems with serial to usb converter, using the Prolific drive. When I activate the device it reboots the PC.

My settings:

Server: Raspberry PI
Client: Windows
Converter: ComTac

Is there a solution to this problem?

Norival Hübner

hello
I have an anti-theft device for the home that you can 'program in usb. when I connect directly to my pc sees the com port 10. when I connect it here on the virtual client sees him as the communication port but the pc (windows 8.1) does not see it.
I also updated the rasp but nothing happens.
all these tests I performed with and without the specific driver installed.
What can I do?

Hi, I'd like to suggest double-click to use and release device (it would be a bit faster and easier than right-click every time).

regards :)

I'm roaming the internet for possible ways to connect a USB keyboard, mouse and MIDI keyboard (M-Audio KeyRig 49) to a computer about 30 kilometers away. At the computer, a student will be working, and the screen of the computer will be shared over optical fiber to my location (I'm a teacher).

Will VirtualHere enable me to connect the keyboard, mouse and MIDI keyboard from my location to the students computer, allowing me to remotely control the computer? I'll have a Raspberry PI at my location running the server software.

Hello.
I'm trying to configure VirtualHere on my OpenWRT server, but so far I've got no success with simple server configuration.
Could you provide me with some hints, ie how to get these values: ,
,

I'm not a professional admin - I'm just a determined user, that needs the functionality of this project to be working in my small company :)